Seite 1 von 1

IKEA Helmet Stand

BeitragVerfasst: Do 11. Aug 2016, 16:02
von GKAM
I first came across a similar helmet stand in our Neustadt meetings and liked the idea immediately. Thinking to myself, these would be even better if one could rotate the helmet for easier display. About a week ago, a SNUDDA Drehplatte smiled at me in IKEA :) . A short stop to the DIY store, and minutes later I had all the simple parts needed to build a rotating stand. Here are some photos for anyone interested.

Take apart the SNUDDA and salvage the large wooden disc and ball bearing assembly.
WP_20160811_09_02_37_Pro.jpg

Center and mount the lower part of the base (assembly comes from a 20cm furniture leg bought in DIY section).
WP_20160811_10_51_42_Pro.jpg

Screw on the tube from the furniture leg and attach the SNUDDA ball bearing assembly with a M10 low profile screw.
WP_20160811_13_17_07_Pro.jpg

Center the ball bearing assembly on a piece of 8mm MDF cut to the shape of a neck gasket.
WP_20160811_13_00_27_Pro.jpg

Detail of MDF gasket spray painted black and secured over the ball bearing assembly.
WP_20160811_15_20_58_Pro.jpg

The finished stand, blending nicely and allowing the helmet to be rotated at will.
WP_20160811_15_23_28_Pro.jpg
WP_20160811_15_23_28_Pro.jpg (36.39 KiB) 6169-mal betrachtet


/GKAM

Re: IKEA Helmet Stand

BeitragVerfasst: Fr 12. Aug 2016, 06:48
von Franz
Hi George!

Compliments, that is a good idea. . . .

: )
Franz